HEMCO_Diagn.rc

In your run directory, you will find a copy of the HEMCO diagnostic configuration file (named HEMCO_Diagn.rc) corresponding to the HEMCO_Config.rc file. You will only need to edit this file if you wish to change the default diagnostic output configuration.

A snippet of the HEMCO_Diagn.rc for the fullchem simulation is shown below:

###############################################################################
#####  ALD2 emissions                                                     #####
###############################################################################
EmisALD2_Total      ALD2   -1     -1  -1   3   kg/m2/s  ALD2_emission_flux_from_all_sectors
EmisALD2_Anthro     ALD2   0      1   -1   3   kg/m2/s  ALD2_emission_flux_from_anthropogenic
EmisALD2_BioBurn    ALD2   111    -1  -1   2   kg/m2/s  ALD2_emission_flux_from_biomass_burning
EmisALD2_Biogenic   ALD2   0      4   -1   2   kg/m2/s  ALD2_emission_flux_from_biogenic_sources
EmisALD2_Ocean      ALD2   101    -1  -1   2   kg/m2/s  ALD2_emission_flux_from_ocean
EmisALD2_PlantDecay ALD2   0      3   -1   2   kg/m2/s  ALD2_emission_flux_from_decaying_plants
EmisALD2_Ship       ALD2   0      10  -1   2   kg/m2/s  ALD2_emission_flux_from_ships

Columns:

  1. netCDF variable name for the requested diagnostic quantity

  2. Species name

  3. Extension number (-1 means sum over all extensions)

  4. Category (-1 means sum over all categories)

  5. Hierarchy (-1 means sum over all hierarchies)

  6. Dimension of data (1: scalar, 2: lon-lat, 3: lon-lat-lev)

  7. Units

  8. Value for the long_name netCDF variable attribute

The prefix (e.g. OutputDir/HEMCO_diagnostics) for HEMCO diagnostics output files are specified in the Settings section of the HEMCO_Config.rc file.